What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Rudder cable dilemma

BGordon

BGordon

Well Known Member
Good evening everyone,
I am getting ready to put my rudder cables in and have an issue. Page 27A of the plans says to use a ms21919dg6 clamp to secure the cable where it leaves the fuselage. However the closest I can find in the hard ware is on page 3, bag 1974, ms21919wdg6. Is there a typo? Is this the same piece?
As always thanks,
Brandon
 
BGordon said:
Good evening everyone,
I am getting ready to put my rudder cables in and have an issue. Page 27A of the plans says to use a ms21919dg6 clamp to secure the cable where it leaves the fuselage. However the closest I can find in the hard ware is on page 3, bag 1974, ms21919wdg6. Is there a typo? Is this the same piece?
As always thanks,
Brandon
Click to expand...

The wdg clamps are improved versions of the dg clamps. They have a rubber tab on them than better supports what you are clamping (especially wiring) and are virtually interchangeable.

Build on!
 
You must log in or register to reply here.
Back
Top