This may have been covered in a previous thread but I searched quite extensively and couldn't find anything. I seem kind of stumped and was looking to the experts for some advice. I followed the steps outlined on page 25-3 of the fuse build exactly. I temporarily mounted the landing gear amount after final drilling the top row of holes with a #12 drill. I used the F drill bushing, a #30 drill followed by removal and final drill with a #12. When I go to remount the WD-1021 the holes don't exactly line up and it's **** near impossible to pass an AN-3 in any hole.
What am I missing?
The mounts are not warped as some others builders have encountered.
Do you match drill once it's all on?
I can't even imagine installing this with all the skins surrounding it
Thanks in advance for any help
What am I missing?
The mounts are not warped as some others builders have encountered.
Do you match drill once it's all on?
I can't even imagine installing this with all the skins surrounding it
Thanks in advance for any help