1001001
Well Known Member
When assembling the aileron pushrod for drilling on page 23-3, there is an extremely tight interference fit between the W-1018A rod and the AN490HT8P rod end. I can't fully assemble just yet without using a press. Even after polishing the inside of the pushrod, the fit is extremely tight, and I don't believe I would be able to disassemble the parts for hole deburring etc.
What have others done here? Pressed the parts together and assembled permanently without deburring? Bored out the tube? Turned down the rod end on a lathe?
Something else?
What have others done here? Pressed the parts together and assembled permanently without deburring? Bored out the tube? Turned down the rod end on a lathe?
Something else?