What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Displaying timing advance and MAP on Skyview

C

cbennet1

Well Known Member
Installing a LSE Plasma III and would like to use a spare input on the EMS to display timing advance.

In addition, rather than splitting the MAP line between the Skyview sensor and the LSE ECU, I assume I could use the LSE output for MAP as a replacement to the Skyview sensor.

Anyone done either of these? Did it work or were there issues?

Craig
 
cbennet1 said:
Installing a LSE Plasma III and would like to use a spare input on the EMS to display timing advance.

In addition, rather than splitting the MAP line between the Skyview sensor and the LSE ECU, I assume I could use the LSE output for MAP as a replacement to the Skyview sensor.

Anyone done either of these? Did it work or were there issues?

Craig
Click to expand...

I hve a voltage output on my Electroair ignition that provides a 10mV per degree signal representing timing. I created an input that displays this on my SkyView screen as 'DEGREE PSI'. This can be any of the non-temperature inputs. See Dynon Forum.
 
You must log in or register to reply here.
Back
Top