bschweinberg
Member
Page 9-20, Step 9 of the empennage plans say to rivet the E-01410 Trim Tab Reinforcement Doubler to the E-00902-1L Rear Spar using AN470AD3-3.5 rivets.
1. How did others rivet these three rivets? Did you get a bucking bar into the trim access cavity?
I would think that blind rivets for these three holes would be fine. Did anyone use blind rivets instead? If so, what did you use?
Thanks
Bill S.
Builder #140100
1. How did others rivet these three rivets? Did you get a bucking bar into the trim access cavity?
I would think that blind rivets for these three holes would be fine. Did anyone use blind rivets instead? If so, what did you use?
Thanks
Bill S.
Builder #140100