HAL Pilot
Well Known Member
Aloha
There are three Nut plates locations on the top aft of the fuselage on P10-32.
One On panel F-01475 and one ea. on F-01474 L/R
It appears that these nut plates are attached on page 12-12. Would it not be easier to attach these before these skins go on and then just drill through the nut plate with a smaller drill bit with a 90deg drill from underneath?
Am I missing something?
https://www.dropbox.com/s/c94zi3uf4ldv4yt/Nut plate Q.jpg?dl=0
There are three Nut plates locations on the top aft of the fuselage on P10-32.
One On panel F-01475 and one ea. on F-01474 L/R
It appears that these nut plates are attached on page 12-12. Would it not be easier to attach these before these skins go on and then just drill through the nut plate with a smaller drill bit with a 90deg drill from underneath?
Am I missing something?
https://www.dropbox.com/s/c94zi3uf4ldv4yt/Nut plate Q.jpg?dl=0
Last edited: