Originally Posted by Mich48041
Is it possible to salvage the male connector off from an old defective Ducati regulator?
Joe – Good question.
I wondered the same thing and had a look at some of the photos available showing the circuit boards of failed Ducati units. I suppose it is doable to salvage a male connector housing, but it appears as though leads on the connector housing make a 90 * bend where it is soldered onto the circuit board … so I think the result would be really kludged. Plus, there is no insulation between the individual circuit contacts that exit the body of the connector housing.
RV-12 Wings, Empennage, Fuselage, Finishing, Avionics and Powerplant kits all completed
Dues paid until September 2017