What is the best method to match drill pre-existing holes for the AN3 bolts in the fuse for a newly built HS? This seems one of those critical operations with no do over capability. I need to align the new HS perfectly to the existing holes in the fuse, and perfectly drill the HS and not enlarge the existing holes.
The back story is I am replacing a HS that I acquired as part of the kit from another builder. Oh, and also replacing the VS. These are the only two structures not built by me. This is not just for fun, I discovered an issue with the HS that is not easily fixed...
Regards,
Chris
The back story is I am replacing a HS that I acquired as part of the kit from another builder. Oh, and also replacing the VS. These are the only two structures not built by me. This is not just for fun, I discovered an issue with the HS that is not easily fixed...
Regards,
Chris