sapeloson
Well Known Member
After doing my research I decided to do the "Gear Tower Mod" including the lower two holes in the F802-C R1 & L1. I noticed my access cover will partially cover a 5/32" hole adjacent to the 10th rivet up from top of the WD813-1 weldment. It's the same on both the left and right towers. My questions are:
1.) What is this for?
2.) Is it something I can move?
3.) If not, do I need to make room for it in my cover panel?
Thanks for all your help!
Tim
1.) What is this for?
2.) Is it something I can move?
3.) If not, do I need to make room for it in my cover panel?
Thanks for all your help!
Tim