claycookiemonster
Well Known Member
In performing the SB 14-01-31, I buggered up the HS-814 Splice Angle. My kit (#81651) was ordered sometime in 2002, and at that time the HS-814 was fabbed by the builder from a piece of .125 X 1X 1 angle. I can't find the directions or dimensions or diagram within my plans to help me re-fab one. I have a current replacement HS-814 (the hole positions in these completed new HS-814's are wrong, can't use it) so I can backward engineer one if I must, but I'd really like to have the instructions as given back then.
Anyone got an old set of plans that show how to make this?
Anyone got an old set of plans that show how to make this?