Just curious...but Van's just issued this plans change:
"Page 17-02 Rev 2: In Step 4, changed ?Final-Drill #22? to ?Final-Drill #20.? "
That was a while ago for me and for the life of me I can remember what I did. I checked my drill bit inventory and cant find a #22 so my guess is that I used a 5/32 bit because it was so close to a #22 bit... .156" vs. .157"
My guess is also that the change is to allow for a larger hole so that the rivet properly sets (expands). #20 is about .161" dia.
A BSPQ-5 rivet is .157". I don't remember having any problems inserting these rivets. Perhaps they where already punched pretty close to where they needed to be (?).
Anyone else paranoid about this or...remember what you did?
"Page 17-02 Rev 2: In Step 4, changed ?Final-Drill #22? to ?Final-Drill #20.? "
That was a while ago for me and for the life of me I can remember what I did. I checked my drill bit inventory and cant find a #22 so my guess is that I used a 5/32 bit because it was so close to a #22 bit... .156" vs. .157"
My guess is also that the change is to allow for a larger hole so that the rivet properly sets (expands). #20 is about .161" dia.
A BSPQ-5 rivet is .157". I don't remember having any problems inserting these rivets. Perhaps they where already punched pretty close to where they needed to be (?).
Anyone else paranoid about this or...remember what you did?