AboveMSL
Well Known Member
Hello Folks,
I pulled a Goof while drilling a #12 hole that holds an AN3-6A bolt. The bolt is one of four that attaches the VS-01402 bracket to the horizontal stabilizer forward spar. The elongated hole is in the forward spar and the gap from the elongation is slightly shy of 1/32" on the top side . I would appreciate suggestions on how to proceed.
Thanks
I pulled a Goof while drilling a #12 hole that holds an AN3-6A bolt. The bolt is one of four that attaches the VS-01402 bracket to the horizontal stabilizer forward spar. The elongated hole is in the forward spar and the gap from the elongation is slightly shy of 1/32" on the top side . I would appreciate suggestions on how to proceed.
Thanks