What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

G3X touch PFD and MFD to work together correctly

Crafting N112DR

Well Known Member
I have the G3X touch PFD and it works great all by it self, I added a MFD and now the PFD is flagged for all parameters. As far as installing a G3X touch MDF not configured the same as the PFD. What steps do I need to do to get the PFD and the MFD to work together correctly. I did try to installing configuration files but I’m met with a blue swirling icon indication its busy. This only happens for about half a second after that it just disappears and sits there. There does not appear to be any confirmation that is loading. Any help I would so much appreciate.
 
Last edited:
The PFD needs a program jumper to tell what it is, pins 10 to 27 will do it.
 
What I'm I jumping? I plug it into the Sub D plug that said MFD. Stein built the harness, Not sure what you're saying.

Remove the back shell or use an ohm meter and check that there is a jumper installed from pin 10 to 27 on the PFD plug.
 
Back
Top