I need some suggestions.
I'm finally going back to do my flaps, and I'm having a tough time figuring out how to get the last rivet on the FL-905 set.
I don't have enough clearance between the top and bottom of the rib to get even my smallest bucking bar (or no hole squeezer) in.
What have other folks done? I guess I could use a pulled rivet?
Thanks,
-Dan
I'm finally going back to do my flaps, and I'm having a tough time figuring out how to get the last rivet on the FL-905 set.
I don't have enough clearance between the top and bottom of the rib to get even my smallest bucking bar (or no hole squeezer) in.
What have other folks done? I guess I could use a pulled rivet?
Thanks,
-Dan