What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Wing Spar K1000-4 platenut rivet length

nacoblio

Member
So I am working on the first few steps of the wing spar. The instructions have been very clear about what size rivet to use so far during the entire build. I am wondering on the location of the rivet call out for the 2 K1000-4 platenuts? I understand this is a simple fix. I am going to use my rivet gauge and determine what length to use after the platenut is in place but more just so I know where is this information is hidden. Or did they not include it on purpose to make me do one extra step? Thanks in advance.
 
Upper right corner of dwg 10a. -6 rivets. In that area don't try to get ahead by doing the nutplates for the tanks- you need the holes open for now.
 
Upper right corner of dwg 10a. -6 rivets. In that area don't try to get ahead by doing the nutplates for the tanks- you need the holes open for now.
Which ones? The ones on the vertical portion of the spar? Thanks for the point out everyone.
 
Back
Top