IO360 fore-aft dimensional question

I may have posted this info request to the wrong forum. Ideas would be appreciated:

I have been unable to nail down whether or not the parallel valve 180 with CS prop has the same fore-aft dimensions as the angle valve 200 IO360A1A similarly configured. By fore-aft I am referencing motor mounts to crank flange. Anybody send me in the right direction?
Thanks much,
Len

Same length Mount to flange. Difference in published lengths in in the end of the longest accessory to flange. Both use the same crankcase.
Merry Christmas,
Mahlon

thanks!

mahlon_r said:

Same length Mount to flange. Difference in published lengths in in the end of the longest accessory to flange. Both use the same crankcase.
Merry Christmas,
Mahlon

Click to expand...

Mahlon.. most appreciated!!
Len