1- on the HS and VS, they show holes to leave open to attach fairings. I will match drill them, but do I dimple them, or do the attachments later use round heads instead of flat?
2- Reference the pictures below. I need to make a cutout for the elevator control arms to move through a spot in the rear HS spar. The cutout is the hatched section in the second picture. They offer a full-scale drawing of the hinge and horns, but how much clearance do i need around them and the spar? Trying to determine how much to trim widthwise on the spars. Looked ahead in the plans but couldn't find anything.
2- Reference the pictures below. I need to make a cutout for the elevator control arms to move through a spot in the rear HS spar. The cutout is the hatched section in the second picture. They offer a full-scale drawing of the hinge and horns, but how much clearance do i need around them and the spar? Trying to determine how much to trim widthwise on the spars. Looked ahead in the plans but couldn't find anything.
Last edited: