duckworks landing light install

looking for best way to fish wires out to the wing tips for landing lights and N/S tip lights. How to wire two landing lights to single switch on RV 4

Well I put a conduit down my wings so its easy to feed the wires down the conduit. If you tape them together the bundle will be pretty rigid. If you don't have a conduit you can reach in from the access panels and feed it through one rib at a time. It will take longer this way and a helper would be beneficial.

I used a double pole switch with each wing on a separate pole. That way if the switch fails its most likely that I wouldn't lose both of my lights.

I am getting ready to do the same thing. Bought led nav/pos/strobe lights for wingtips and duckworks landing lights for each wing. Hope it isnt too much of a pain to fish wires out