HAL Pilot
Well Known Member
Hey Folks
Reading page 08-04 Step 6 has us machine counter sinking the middle 9 holes on the flanges.
Then on page 08-08 step 4 it says to machine countersink the holes in the spars that correspond to the holes in the skin.
Isn't this all the holes in the spar flanges? The reason I ask is I started two holes early on the "9" hole step, but it seems like a non issue because they all get countersunk.
What am I missing?
Pete
Reading page 08-04 Step 6 has us machine counter sinking the middle 9 holes on the flanges.
Then on page 08-08 step 4 it says to machine countersink the holes in the spars that correspond to the holes in the skin.
Isn't this all the holes in the spar flanges? The reason I ask is I started two holes early on the "9" hole step, but it seems like a non issue because they all get countersunk.
What am I missing?
Pete