Given that I'm still traumatized by my disastrous first-foray into using fuel tank sealant last weekend I've been putting off my next attempt, but trying to remain productive. So, since I was going to have to do it sometime I decided to go ahead and build my wing stand. I modified the EAA design so that the same wingstand could be used with or without the fuel tanks installed and added some additional cross bracing cables. Other than measuring where the saddles should go, I pretty much made it up as I went. Not sure how things are in other parts of the country but here in New Mexico it seems it is impossible to buy lumber that isn't split, twisted, or warped which makes projects like this harder than they should be. Anyway, I'm pleased with how it turned out even with the **** lumber. I'll try adding a photo: