I'm planning to install SDS EFI in my RV-14 and am working on the fuel system. Does anyone else who's done EFI have any suggestions as to where to install the fuel return on the firewall? The two options I've considered are 1. near the existing fuel line hole in the firewall, or 2. up near the location of the stock manifold pressure sensor (upper right).
Location 1 would allow me to keep the fuel lines together. Location 2 is near the typical fuel pressure regulator mounting point and would reduce the amount of "stuff" forward of the firewall.
Thanks!
Location 1 would allow me to keep the fuel lines together. Location 2 is near the typical fuel pressure regulator mounting point and would reduce the amount of "stuff" forward of the firewall.
Thanks!