As promised before, here is some more info about my RV-12 installation
The Dynon SkyView gives an audible alarm (“Flaps Over-speed”) when the flaps are not fully up and the airspeed is over 82 knots.
A micro-switch is activated by the Flap Lever arm on the Aileron control bell-crank, which is below the pilots seat.
The micro-switch grounds EMS input “GP5” (in the manual as “Serial 5”).
This is connected to Pin 9 of the 37 pin connector on the EMS.
The operation of the switch can be checked by means of a “Flaps Widget” on the 100% size EMS screen.
Software changes from the standard SkyView version:
1. Setup Menu > EMS Setup > Sensor Input Mapping > Sensor Setup
EMS c37_p9 set to: POSITION POSITION FLAPS
2. Check that there is a line in the User Config dfg file:
3. Change Widget from “WIDGET_CONTACT” to “WIDGET_FLAPS”.
4. Setup Menu > HW Calibration > EMS Calibration> FLAPS Calibration
You can choose two calibration positions: Say 0 and 20 degrees