What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Question on wiring trimmer servo

romanov

romanov

Well Known Member
Fellows, we have some difference on the servo scheme vs Vans drawings.
Any idea how to connect those pins?

HZfwxEf.jpg


bOzUv6y.jpg


Thanks in advance
Roman.
 
The gray wire in the top drawing is the same as the second white wire in the bottom schematic.

Each white wire drives the trim servo in or out. You can test using a 9 volt battery to ensure you have the correct travel direction / polarity.
 
Raymo said:
The gray wire in the top drawing is the same as the second white wire in the bottom schematic.

Each white wire drives the trim servo in or out. You can test using a 9 volt battery to ensure you have the correct travel direction / polarity.
Click to expand...


So the the connector is like that:

Code: 
2 - ORN
3 - GRN
6 - BLU
5 - WHITE
4 - GREY

is it correct ?

and just curious why the notation says WHY/BLU , WHY/ORN
what does it mean?
 
romanov said:
So the the connector is like that:

......

and just curious why the notation says WHY/BLU , WHY/ORN
what does it mean?
Click to expand...

In most cases a notation like "WHT/BLU" would reference a WHITE wire with a BLUE stripe on it.
 
You must log in or register to reply here.
Back
Top