Xkuzme1
Well Known Member
I have been sitting on a Altrak altitude hold for quite some time. Not super excited to get in the extremely compromising position that will be required to drill out the bell crank mount in the tail. Also not excited to drill out perfectly good rivets and replace them.
Has anyone successfully mounted a pitch trim servo in another place? I considered underneath the back seat, and making a strap to the torque tube. I also considered making a mount in front of the bell crank.
Not just for laziness, but also trying hard to keep my cig as forward as possible. Not excited about mounting a 3 pound servo so far back.
Thoughts?
Thanks.
X
Has anyone successfully mounted a pitch trim servo in another place? I considered underneath the back seat, and making a strap to the torque tube. I also considered making a mount in front of the bell crank.
Not just for laziness, but also trying hard to keep my cig as forward as possible. Not excited about mounting a 3 pound servo so far back.
Thoughts?
Thanks.
X
Last edited: