vbpiper
Well Known Member
I have nearly completed wiring the pins in the connector of the ICOM, but I have one question. The diagram of the Molex connector shows Pin 2 for "detected audio (output)". I am using an external intercom, no remote frequency change switch, no second comm, so do I need to wire this pin?
Also, Pin 10 is for ""squelch cancel". Again, do I need this pin wired if I am using an external intercom?
Help?? Stein? Anyone?
Thanks!.
Also, Pin 10 is for ""squelch cancel". Again, do I need this pin wired if I am using an external intercom?
Help?? Stein? Anyone?
Thanks!.