I'm trying to fit/install the weldments but seem to be having an issue. I can't find any additional places of interference that would be keeping it from sitting all the way against the center spar.
How much can these be off from the manufacturing vs improper installation?
The inboard side is flush against the spar but the outboard angles and creates about 1/8" gap.
Also, even with one end tight against the spar, the bolts would be short. I barely get one thread showing.
Thoughts on issues?
Thank you!
Allen
How much can these be off from the manufacturing vs improper installation?
The inboard side is flush against the spar but the outboard angles and creates about 1/8" gap.
Also, even with one end tight against the spar, the bolts would be short. I barely get one thread showing.
Thoughts on issues?
Thank you!
Allen