cderk
Well Known Member
I'm on page 23-3 and have a quick question on W-1018A parts and how the AN490-HT8P threaded rod ends insert into the tubes. They don't seem to fit well. I'm sure I can jam them in there, but I don't think I'd be able to get them back out again to debur and prime. Is it better to try to ream out the tube or sand down the threaded rod end?
I also noticed that it says to prime this part when done... my pushrod is powder coated white - is it really necessary to prime?
I also noticed that it says to prime this part when done... my pushrod is powder coated white - is it really necessary to prime?