What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Aileron Conterbalance

Bootscooter

Active Member
HI All.

The Aileron counterbalance gets drilled many times. (Page 22-05 refers) It is stainless steel.

Just woundering if anyone had a good tip on deburring after drilling for inside a tube? Especially a stainless steel one.
 
HI All.

The Aileron counterbalance gets drilled many times. (Page 22-05 refers) It is stainless steel.

Just woundering if anyone had a good tip on deburring after drilling for inside a tube? Especially a stainless steel one.

Greetings hangar mate!
I deburred the ones at each end (where the screws and nuts hold it to the ribs) with the dremel.
I didn't worry about the rest of them.
Cheers.
 
I used what we call a flap wheel. It's like a sanding drum but it's made up with pieces of sanding paper. Each piece of paper can flap as the drum turns. I used a bunch of shaft extensions for the reach.
 
Back
Top