charosenz
Well Known Member
brake line exit Fuse on RV6A?? Pics??
I am debating on where exactly to exit the fuse with the brake lines on my RV6a. I have read a bit about the various choices of drilling through the gear weldments vs bringing the fitting out above the weldment vs bringing them out the center of the fuze over to the gear leg.
I would really appreciate some pics on how guys did this.
I am leaning on bringing them out about 1-1/4" up from the floor, about 1-1/2 to 2-1/2 inches forward of the spar.
The drawings do not show a real precise location.
Thanks!
Charlie
I am debating on where exactly to exit the fuse with the brake lines on my RV6a. I have read a bit about the various choices of drilling through the gear weldments vs bringing the fitting out above the weldment vs bringing them out the center of the fuze over to the gear leg.
I would really appreciate some pics on how guys did this.
I am leaning on bringing them out about 1-1/4" up from the floor, about 1-1/2 to 2-1/2 inches forward of the spar.
The drawings do not show a real precise location.
Thanks!
Charlie
Last edited: