I've read all the posts on this, but have a question with my setup.
I think that the flaps are designed to be fully up when they hit the stops. On my wings when I put the flaps in the up stop, and then apply the aileron alignment tool, my aileron edge is approx 1/4 inch below the flap. If I rig the aileron at the flap it will be higher than the tool shows.
I'm inclined to rig the aileron where the tool has it rigged, and then set the flap for full up where the aileron lines up.
The reason I care is that I'd really like to do my wingtips in the stand before I hang the wings on the plane.
Does anyone have a simple step by step so I can get it right in the wing stand?
I think that the flaps are designed to be fully up when they hit the stops. On my wings when I put the flaps in the up stop, and then apply the aileron alignment tool, my aileron edge is approx 1/4 inch below the flap. If I rig the aileron at the flap it will be higher than the tool shows.
I'm inclined to rig the aileron where the tool has it rigged, and then set the flap for full up where the aileron lines up.
The reason I care is that I'd really like to do my wingtips in the stand before I hang the wings on the plane.
Does anyone have a simple step by step so I can get it right in the wing stand?