SkyView map screen turned red!
Airplane has been flying perfectly and Skyview has been great. Until today.
After start up today the map section assumed an orange/red color. Every other aspect of Skyview worked as per normal.
Its a Skyview Touch single screen set-up with SV 13.03 and all the updates are current.
If I touch the screen e.g.. touch the + or - sign on the screen to change the range the proper map color comes in, but as soon as I take my finger off it goes back the orange hue.
The route, obstacles, traffic, airports etc are all there as per normal but the orange is blocking out key features such as a Class C airspace near me. As I was flying trying to figure it out it occurred to me that it was like being in a TFR but?.there is no active TFR anywhere near where I was flying.
I tried looking through manual, on this site and haven't found anything. There are no warnings or flags saying if there is a problem. I shut it down and started it up a couple of times and it does the same thing.
The PFD and EMS sections are completely normal.
I tried calling Dynon Tech Support but its a Saturday.
So the question is?.has anyone seen this before? Can anyone point to anywhere in a manual that would explain the problem and offer a fix? Could this be a glitch in Skyview or the info Skyview is getting through ADSB?
I've already had to send this unit back because of a faulty memory module. I have a 2014 RV-12 SLSA!
Thanks for any help!
Airplane has been flying perfectly and Skyview has been great. Until today.
After start up today the map section assumed an orange/red color. Every other aspect of Skyview worked as per normal.
Its a Skyview Touch single screen set-up with SV 13.03 and all the updates are current.
If I touch the screen e.g.. touch the + or - sign on the screen to change the range the proper map color comes in, but as soon as I take my finger off it goes back the orange hue.
The route, obstacles, traffic, airports etc are all there as per normal but the orange is blocking out key features such as a Class C airspace near me. As I was flying trying to figure it out it occurred to me that it was like being in a TFR but?.there is no active TFR anywhere near where I was flying.
I tried looking through manual, on this site and haven't found anything. There are no warnings or flags saying if there is a problem. I shut it down and started it up a couple of times and it does the same thing.
The PFD and EMS sections are completely normal.
I tried calling Dynon Tech Support but its a Saturday.
So the question is?.has anyone seen this before? Can anyone point to anywhere in a manual that would explain the problem and offer a fix? Could this be a glitch in Skyview or the info Skyview is getting through ADSB?
I've already had to send this unit back because of a faulty memory module. I have a 2014 RV-12 SLSA!
Thanks for any help!
Last edited: