rcarsey
Well Known Member
I finally got to the point where all of my wiring is done and I decided to flip the MASTER ON to see what happens 
A few things didn't go quite right and I'm just now beginning to double check my work. But the most obvious problem is that I popped the 30A "EMS Backup Battery". Ok something past the breaker is grounded out..
I found that the wire to the LED of the switch was hooked up to the wrong terminal. Not sure how or when it happened, but the wire on 4 should be on 8.
Just posting in case anyone else experiences the same thing.
If your top center terminal is empty, then its wrong.
A few things didn't go quite right and I'm just now beginning to double check my work. But the most obvious problem is that I popped the 30A "EMS Backup Battery". Ok something past the breaker is grounded out..I found that the wire to the LED of the switch was hooked up to the wrong terminal. Not sure how or when it happened, but the wire on 4 should be on 8.
Just posting in case anyone else experiences the same thing.
If your top center terminal is empty, then its wrong.
Last edited:
