Lynnb
Well Known Member
So I've been reading, downloading, more reading, looking at pictures etc trying to figure out where to start or not start on the door frame. Over the weekend I cut and fit the cabin top, still need to sand a couple of areas, but I didn't cut any of the door opening, or rear window frames for that matter. Now to my questions:
Just an Edit: I intend to install the mcmaster door seals.
1. Do I make a preliminary trim of the door frame to the Van's scribe lines, knowing you will cut more off later to fit the door seals?
Or
2. Do I cut nothing until I start fitting the doors?
Just curious how others approached this.
Thanks,
Lynn
Just an Edit: I intend to install the mcmaster door seals.
1. Do I make a preliminary trim of the door frame to the Van's scribe lines, knowing you will cut more off later to fit the door seals?
Or
2. Do I cut nothing until I start fitting the doors?
Just curious how others approached this.
Thanks,
Lynn
Last edited: