Originally Posted by BrianDC
Whatever you end up doing, post how it works out. I'm basically doing the same setup but haven't run the lines yet. Figured I would be working the details out on it in the next few months.
So obviously I have a long way to go before I install or even test fit my wings, but after looking at some of Bob's photos on his kitlog site I decided to install the return just above and slightly behind the supply as shown below.
Putting it more forward (forward of the hole for the controls) risks interference with the aileron controls and possibly the tank attach bracket of the tank.
Below is Bob's image showing the area between the tank and the fuse.
The red arrow is appox. where my fuel return is mounted on the tank. It's pretty close to a straight shot from the fuse to the fitting.
Probably won't know how this works until much later in the build.