Hi fellow builders.
I hit a hurdle today. I am working on VS Page 06-05. Under step 3 it says Rivet VS-1208 and there are two parts being MS21051-L3 to be attached during the riveting.
When I line up the MS parts the 2 holes for a standard LP4-3 rivet on the sides (single tab) shown on drawing Figure 2 appear to be a long way out of alignment. I could flex them to line up but it does not look right.
Anyone remember this step and have a similar non alignment?
Jim.
I hit a hurdle today. I am working on VS Page 06-05. Under step 3 it says Rivet VS-1208 and there are two parts being MS21051-L3 to be attached during the riveting.
When I line up the MS parts the 2 holes for a standard LP4-3 rivet on the sides (single tab) shown on drawing Figure 2 appear to be a long way out of alignment. I could flex them to line up but it does not look right.
Anyone remember this step and have a similar non alignment?
Jim.