I have a Garmin set up with the G3X Touch, Garmin servos, and the 307 autopilot control head in my RV 10. I used the recommended setting, that Garmin provides, for the AP configurations. I keep getting a pulsing one per, a small pulsing about a second or two apart on the pitch Servo. I can see the edge of the elevator slightly pulsating. When I press the CWS the pulsating stops, so I know it is coming from the pitch Servo. I checked and everything is tight and secure with the servos. I sent an e-mail to Garmin, but since it is the weekend I figure I would reach out to see if I should change something in the configuration. The AP captures and holds the altitude perfectly. No seeking or wandering issues. Just getting that little continuous pulsating.
Last edited: