Ted Christopher
Member
Does anyone have experience lifting an RV 12 as it shows in the manual, with sturdy saw horses under the tail and nose section. Mine has only been lifted by the A&P using jacks under the wings (and cushioned boards) but I don't have jacks and would like to be able to service my own tires.
I think I would build a cushioned support a couple inches higher that the front belly of the plane, press down on the tail, put it the front support in place and lift up the tail with a jack of some sort under the tail cone using a cushioned board, then lower the rear tie down ring onto the support I've built.
Does this sound right?
I think I would build a cushioned support a couple inches higher that the front belly of the plane, press down on the tail, put it the front support in place and lift up the tail with a jack of some sort under the tail cone using a cushioned board, then lower the rear tie down ring onto the support I've built.
Does this sound right?