VansAirForceForums  
Home > VansAirForceForums

- POSTING RULES
- Donate yearly (please).
- Advertise in here!

- Today's Posts | Insert Pics

  #1  
Old 04-06-2018, 07:21 PM
RV3Kev RV3Kev is offline
 
Join Date: Sep 2017
Location: Traralgon Australia
Posts: 9
Default RV3 Rudder Horn

I'm in the process of shaping the rudder horn of the RV3. The drawing call for a radius of 5/16" in each corner. A 1/4 " hole is then drilled at the centre of the radius at each of the corners. By my calculation this only leaves 3/16" edge distance. Why so little? The length of the clevis for the rudder cables is at least 1/2", so the edge distance can be much greater than 3/16". Note that a 3/16" ID bronze insert is use the 1/4" inch hole.

Any comment? Did any do any thing different when locating these holes.
Reply With Quote
  #2  
Old 04-06-2018, 08:03 PM
Rv3Dave Rv3Dave is offline
 
Join Date: Jul 2016
Location: Florida
Posts: 31
Default

Built mine by the plans, but donít see an issue if you want to slightly increase the edge distance
Reply With Quote
Reply


Thread Tools Search this Thread
Search this Thread:

Advanced Search
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -6. The time now is 12:21 AM.


The VAFForums come to you courtesy Delta Romeo, LLC. By viewing and participating in them you agree to build your plane using standardized methods and practices and to fly it safely and in accordance with the laws governing the country you are located in.