Hey gang,
I bought some aftermarket trim cable attachment brackets to replace the stock WD-415s that came with the kit. Like a bonehead, I pitched the OE brackets before realizing that the base dimensions are different. Now, I don't know the dimensions needed to calculate their position on the E-616 cover plates, since the plans on Page 9-7, step 4 only show the distance from the opening to the furthest edge of the bracket!
Would anyone happen to know the dimensions of the WD-415 bracket base (OR their distance from the opening to the nearest bracket edge)?
Worst case, I could spend a few extra bucks on my "next" shipment of "replacement" parts to get another bracket, but was hoping someone would have easy access to the answer (and help me save a few $$ on something I would discard again anyway)...
Thanks!
Tom
I bought some aftermarket trim cable attachment brackets to replace the stock WD-415s that came with the kit. Like a bonehead, I pitched the OE brackets before realizing that the base dimensions are different. Now, I don't know the dimensions needed to calculate their position on the E-616 cover plates, since the plans on Page 9-7, step 4 only show the distance from the opening to the furthest edge of the bracket!
Would anyone happen to know the dimensions of the WD-415 bracket base (OR their distance from the opening to the nearest bracket edge)?
Worst case, I could spend a few extra bucks on my "next" shipment of "replacement" parts to get another bracket, but was hoping someone would have easy access to the answer (and help me save a few $$ on something I would discard again anyway)...
Thanks!
Tom