Michael Burbidge
Well Known Member
I'm installing a new JPI engine monitor. The JPI Oil temperature probe installation instructions say to install the probe in one of the front oil gallies, by removing the 1/8 NPT plug.
So far I've not been able to budge the galley plug on either side of the engine. I'm wondering why I can't install the probe in the oil filter adapter where the existing oil temperature probe is installed.
The oil filter adapter accepts a 5/8 inch straight thread. There's an adapter for 5/8 in straight thread to 1/8 NPT that I could use.
The instructions however say not to install the probe near the vernatherm. I believe the vernatherm is in the oil filter adapter on Lycomings.
I'm wondering if I can install the probe in the oil filter adapter using the adapter.
Has anyone else installed a JPI oil temperature probe there?
Here's a picture of the old probe and location.
So far I've not been able to budge the galley plug on either side of the engine. I'm wondering why I can't install the probe in the oil filter adapter where the existing oil temperature probe is installed.
The oil filter adapter accepts a 5/8 inch straight thread. There's an adapter for 5/8 in straight thread to 1/8 NPT that I could use.
The instructions however say not to install the probe near the vernatherm. I believe the vernatherm is in the oil filter adapter on Lycomings.
I'm wondering if I can install the probe in the oil filter adapter using the adapter.
Has anyone else installed a JPI oil temperature probe there?
Here's a picture of the old probe and location.
Last edited: