I ran into the step asking me to put RTV on to seal the gaps between the baffle and the engine. I assume that is everywhere on top where air can go out without going past a cylinder fin. There are places where the baffle does a good tight fit at the fin edges and I wonder if I really need RTV there.
Or is this intended to be mainly sealing the baffling interface to the engine CASE? If I did RTV between engine case and the baffling, along with sealing some small holes in the baffle joints, that would be pretty efffective. In that case no RTV on any cylinder, just baffle/case and some baffle corners.
Anyone have any pics with arrows of what to seal if doing it perfectly by the plans?
Or is this intended to be mainly sealing the baffling interface to the engine CASE? If I did RTV between engine case and the baffling, along with sealing some small holes in the baffle joints, that would be pretty efffective. In that case no RTV on any cylinder, just baffle/case and some baffle corners.
Anyone have any pics with arrows of what to seal if doing it perfectly by the plans?