What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

Dumb Q. on wing tips

az_gila

az_gila

Well Known Member
What tools do you use for the #6 dimples for the wing tips?

When I built my -6A I ensured that there was enough clearance here since IIRC the pans called for 1/8 pop rivets. Since the kit was not a pre-punched one that was relatively easy.

The clearances here are too small for a regular dimple tool.
 
I?m honestly not sure. But I think I used a pneumatic squeezer, ?backwards? (e.g., male die in the ram arm, female die in the fixed arm.).
 
You must log in or register to reply here.
Back
Top