oren_rokach
Well Known Member
Hi,
I am designing my avoinics panel, and wish to put the cabin heat knobs on the right side. see the two knobs near the 12v port, below the 7" display
https://drive.google.com/file/d/1WMidUrRBe0tHG0oJXEyx1k6PTZ4a9m0F/view?usp=sharing
Can you comment on my suggested location? would be easy to route the cables to this location? I understand that routing/bending them is quite difficult, even though by browsing through so many panels, I see builders locating them practically anywhere.
are you using aftermarket SS penetrations for these?
Any guideline would be very helpful!
Can anyone share some pics of their FW penetration of those cables?
Thanks!
Oren
I am designing my avoinics panel, and wish to put the cabin heat knobs on the right side. see the two knobs near the 12v port, below the 7" display
https://drive.google.com/file/d/1WMidUrRBe0tHG0oJXEyx1k6PTZ4a9m0F/view?usp=sharing
Can you comment on my suggested location? would be easy to route the cables to this location? I understand that routing/bending them is quite difficult, even though by browsing through so many panels, I see builders locating them practically anywhere.
are you using aftermarket SS penetrations for these?
Any guideline would be very helpful!
Can anyone share some pics of their FW penetration of those cables?
Thanks!
Oren