HI,
Building with a full suite of Garmin LRU's
I am building in a small garage and cannot fit the wings on to the fuselage. I wanted to check the CanBus and configure as much as possible before taking the the aircraft to the airfield (hours away). Therefore I made temporary jump leads on all wing to fuselage connections.
This worked well, however, my PFD is black instead of blue and brown (or synthetic).
I have not been able to configure the ADAHRS, Magnetometer and AOA as these require fully assembled aircraft at the airfield.
I am thinking that the reason for the black screen is because these are not configured. However, I would welcome any assistance/information as to the situation I have.
Regards John
Building with a full suite of Garmin LRU's
I am building in a small garage and cannot fit the wings on to the fuselage. I wanted to check the CanBus and configure as much as possible before taking the the aircraft to the airfield (hours away). Therefore I made temporary jump leads on all wing to fuselage connections.
This worked well, however, my PFD is black instead of blue and brown (or synthetic).
I have not been able to configure the ADAHRS, Magnetometer and AOA as these require fully assembled aircraft at the airfield.
I am thinking that the reason for the black screen is because these are not configured. However, I would welcome any assistance/information as to the situation I have.
Regards John