What's new
Van's Air Force

Don't miss anything! Register now for full access to the definitive RV support community.

E-404 tip rib

RyanB

Active Member
I am busy assembling my elevators and am now instructed to attach the small E-404 tip rib to the spar, but the flange on the rib that attaches to the spar has not been bent, it just extends straight back from the rib. Is this done intentionally by Vans and if so how do you know where to bend it as the plans aren?t telling me anything.

Hope this makes sense

Thanks in advance
 
Dwg 4a

Ryan,
Was recently going though this myself. If you look at Dwg 4a section B-B, towards the left of the drawing. You can see the show the flange bent up about 5/8 like the other flanges. But I think you need to adjust that to get E404 to stand proud of E403 as shown. Hope this helps
 
Tip Rib

It certainly does thank you, so am I then correct in saying that you first installed the E403 rib and then the E404 rib?
 
404

Hi, sorry for late reply. I ended up bending the flange and it all worked out perfectly.
 
Back
Top