Well I know this has been done before but I thought I'd share my version of this install.
Previously I had installed the Duckworks leading edge landing light kit. Not knowing exactly which lamp assembly I was going to install, I bought the Blank Lampless Install Kit.
So I decided to install a taxi light in the leading edge and a landing light in each wingtip.
The taxi light is the Baja Designs Squadron Sport Flush Mount Driving/Combo
. This is a 20 watt 1.4 amp unit.
The landing lights will be the Squadron Pro, Flush Mount, LED Spot
Those units are 40 watt 3.33 amps.
Here are some photos of the taxi light install:
Finding the center of the opening.
The Duckworks bracket with the template laid out.
Here is the BD combo installed.
Here's the backside...very simple install.
Although this is probably not a very good representation of the light...I couldn't resist checking it out.
sagriver at icloud dot com
RV-7 Slider #74572
Empennage completed 11/2016 (sans fiberglass)
Ailerons and flaps completed 3/2017.
Wings completed 12/2017 (sans fiberglass)
Started on QB fuselage 01/2018
Donated and so should you