sensor connections

R

Ron B.

Well Known Member

• Apr 2, 2019

• #1

On a Rotax 912 , do we use spade connectors to slip over the end of the CHT/oil sensors ? Do we need to install some kind of protective boot after connection is made ?
Thanks Ron

 

R

RFSchaller

Well Known Member

• Apr 2, 2019

• #2

I never installed any boots. After almost 850 hours and 7 years there have been no issues.

 

R

Ron B.

Well Known Member

• Apr 3, 2019

• #3

Thanks, I finally found a photo confirming the spade connection.

 

Piper J3

Well Known Member

• Apr 3, 2019

• #4

No boots - open connectors. At condition inspection I spray the connectors with contact cleaner/lubricant. Works good with no electrical problems - 400TT.