oren_rokach
Well Known Member
Hello
I have installed the parking break and when screwing the AN3-12 bolts into the firewall bracket, the arm stops moving!
Have anyone encountered such issue?
We are suspecting that it is caused by a manufacturing tolerance between the two parts, so when pressed together creates a bend in the shaft which stops the arm.
see picture below:
https://photos.app.goo.gl/yfv3oWXeMSfDytTo9
See below the 0.02" gap between the two?
I was thinking of installing a shim behind one of them, to close the gap.
Ideas?
Thanks
Oren
I have installed the parking break and when screwing the AN3-12 bolts into the firewall bracket, the arm stops moving!
Have anyone encountered such issue?
We are suspecting that it is caused by a manufacturing tolerance between the two parts, so when pressed together creates a bend in the shaft which stops the arm.
see picture below:
https://photos.app.goo.gl/yfv3oWXeMSfDytTo9
See below the 0.02" gap between the two?
I was thinking of installing a shim behind one of them, to close the gap.
Ideas?
Thanks
Oren
Last edited: