G3X and Kavlico sensors wiring

Anybody find a neat way to connect the shielded wires from the GEA-24 to mate with the Kavlico sensor 16GA wires? I'm talking about the manifold, fuel, oil press sensors. Seems like a 9 wires spliced together in such close proximity would just look bulky and unprofessional.

Pics would be great!

Jay
jaysrv9a at gmail.com

Buy a new Connector

One hint is to simply buy a new connector and associate pins. They are Delphi Metri Pack 150 connectors. You can get the connectors and pins at Digikey. That way you don't end up with a splice right at the end. If you use the Van's VA-168 manifold, then all of the three connectors are in one place. The way I fit it on the firewall it ended up right next to the oil temperature probe as well, so all four are there. Each of the pressure transducers has its own 3 conductor shielded cable. The temperature probe is a 2 conductor shielded cable.


You can see mine (on a Cozy, not an RV) here: