So, I think I made a mistake that may induce a twist into my right elevator. A year ago I dimpled, clecoed and match drilled the skins to the skeleton on my right elevator without bending the trailing edge. Looking back I am not sure why I thought that was a good idea.
My question is;
Will this induce a twist, and if it does, is it ok to match drill the holes again once everything is straight?
Do I need to buy a new skeleton?
My question is;
Will this induce a twist, and if it does, is it ok to match drill the holes again once everything is straight?
Do I need to buy a new skeleton?